Add Rubber Feet To Bottom Of Mounting Boards; Clamp Mounted Saw To Stand And Prepare For Use - Craftsman 695.22302 Owner's Manual

MOUNTTHE MITERSAW, cont.
ADD RUBBER FEET TO
BOTTOM OF MOUNTING BOARDS
(Figures 36 and 37)
Remove boards from stand and drill two pilot holes for Screws (W) to
attach rubber feet (V). The holes should be 5/64-inch diameter and
1/2=inch deep. (Four screws included.)
Attach two rubber feet to each board as shown in Figure 37. These help
provide cushioning and protection when the miter saw is not mounted to the
stand. Install rubber feet IY2" from edge of board as shown.
Not all miter saws mount the same. You may need to
adjust location of foot pads to avoid saw-mounting screws,
Fig. 36
w (four)
Fig. 37
CLAMP MOUNTED SAW TO STAND AND PREPARE FOR USE
(Figure 38}
Mount saw to boards and place boards on center of stand. Position for best
balance° This usually places the fence of the saw in the center of the stand,
front-to-back, See Ffgure 3&
Position clamp brackets in slots of boards and tighten securely,
With telescoping extensions pushed in, set height of supports even with
table of miter saw.
Extend telescoping extensions to support workpieces and position edge
guide and stop as required.
26