Mounting Bolt; Mounting Washer; Spring Washer - Craftsman 320.16491 Operator's Manual

Mounting Standard Miter Saws
To The Stand
NOTICE: This allows for the miter
saws on which the 4 mounting
holes form a rectangular pattern
(most miter saws).
1. Mount your miter saw to
the quick-release mounting
brackets (B) using the miter
saw mounting bolts (F),
washers (G), spring washers
(H) and locking nuts (I) (Fig. 5).
2. With the miter saw mounted
on the quick-release mounting
brackets, place the assembly
on the work stand (Fig. 6).
INSTALLING THE
QUICK=RELEASE
MOUNTING BRACKETS
1.
Hold the quick-release
mounting bracket (B) by
the handles.
2. Position the area designated
"Z" in Fig. 7 on the frame
assembly (A).
3. Press the handle down to
mount the quick-release
mounting brackets (B).
4. Tighten the locking lever
to lock the mounting
brackets (B) (Fig. 8).
Fig. 5
Fig. 6
2
Fig. 7 Handle
Fig. 8
locking lever
Page 10 16491 ManuaLRevised_12 0606