Craftsman 82140 Owner's Manual page 9

i WARNING: To avoid electric shock, disconnect the test leads from any I
source of voltage before removing the battery door.
I
1.
2.
3.
4.
Disconnect the test leads from the meter.
Remove the protective rubber holster (if installed).--_._
Open the battery door by loosening the screw using a
Phillips head screwdriver.
Insert the battery into battery holder, observing the
correct polarity.
Put the battery door back in place. Secure with the
screw.
i WARNING: To avoid electric shock, do not operate the meter until the I battery door is in place and fastened securely.
I
NOTE: If your meter does not work properly, check the fuses and batteries
to make sure that they are still good and that they are properly inserted.