GE Profile 25 Owner's Manual And Installation page 12

About the automatic icemaker.
A newly installed refrigerator may take 22 to 24 hours to begin making ice.
On dispenser models,
to access ice or reach
the power switch:
O Pull the bin forward until the
bin stops.
_Lf
O Lower the bin to access ice
or reach the power switch.
Automatic Icemaker
The icemaker will produce seven cubes
per cycle-approximatelg 100-130 cubes
in a 24-hour period, depending on freezer
compartment temperature, room
temperature, number of door openings
and other use conditions.
If the refrigerator is operated before the
water connection is made to the icemaker,
set the power switch in the OFFposition.
When the refrigerator has been connected
to the water supplg, set the power switch
to the ON position.
The icemaker will fill with water when it cools
to !5°F (-!0°C). A newlg installed refrigerator
mag take 12 to 24 hoursto begin making
ice cubes.
You will hear a buzzing sound each time
the icemaker fills with water.
Throw uwag the first few batches of ice
to allow the water line to clear.
Be sure nothing interferes with the sweep
of the feeler arm.
Special note about dispenser models:
Dispensermodels have a tilt-out ice bin.
The bin can be tilted out as shown in the
illustrations, and it will hold itself up while
gou take ice out or turn the icemaker
power switch on and off. Be sure to put the
bin back in place before closing the door.
To restore your ice level from an empty
bucket stage, the following steps are
recommended:
O 12 hours after the first butch of ice has
fallen into the bin, dispense 3 to 4 cubes.
O After an additional 6 hours, dispense
3 to z_ cubes again.
These steps will restore gout ice level in
the shortest amount of time.
When the bin fills to the level of the feeler
arm, the icemaker will stop producing ice. X
It is normal for several cubes to be joined
Power-"
together,
switch FeelerAim .................
If ice is not used frequentlg, old ice cubes will
become cloudg, taste stale and shrink.
Removing Ice Bin Idispenser models)
CAUTION:Theice bin is heavy when full.
Setthe power switch to the OFFposition
before removing the bin.
When replacing the bin, be sure to press
it firmlg into place. If it does not go all the
wag back, remove it and rotate the drive
mechanism 1/4 turn. Then push the bin
back again.
Dispenser Models only
12