Important Safety Instructions - Epson GT-7000 Photo User Manual

Important Safety Instructions

Read all these instructions and save them for later reference.
Follow all warnings and instructions marked on the scanner.
Unplug the scanner before cleaning. Clean with a damp cloth
only. Do not spill liquid on the scanner.
Do not place the scanner on an unstable surface, or near a
radiator or heat source.
Use only the type of power source indicated on the scanner's
label.
Connect all equipment to properly grounded power outlets.
Avoid using outlets on the same circuit as photocopiers or air
control systems that regularly switch on and off.
Do not let the power cord become damaged or frayed.
If you use an extension cord with the scanner, make sure the
total ampere rating of the devices plugged into the extension
cord does not exceed the cord's ampere rating. Also, make
sure the total ampere rating of all devices plugged into the
wall outlet does not exceed the wall outlet's ampere rating.
Except as specifically explained in this User's Guide, do not
attempt to service the scanner yourself.
Unplug the scanner and refer servicing to qualified service
personnel under the following conditions:
If the power cord or plug is damaged; if liquid has entered the
scanner; if the scanner has been dropped or the case damaged;
if the scanner does not operate normally or exhibits a distinct
change in performance. (Do not adjust controls that are not
covered by the operating instructions.)
If you plan to use the scanner in Germany, observe the
following:
3
Introduction