KitchenAid KSSC36FJB00 Installation Instructions Manual page 11

top grille
assembly
15.
Wraparound metal door
models: go to step 17.
Panel models: Slide decorative panel
assembly up to remove from top grille
assembly.
remove 2
screws
top grille decorative
panel
16.
Panel models: Remove screws
and side trim from one side of the
decorative panel. Insert your panel.
Reattach side trim and screws.
cabinet
grille panel
side trim
grille panel
screws
17.
Panel models: Slide
decorative panel down to reattach to
top grille.
18.
If side panels are not used,
go to Step 19.
If built-in area depth is 25"
(63.5 cm) or more, side panels can be
installed inside the side trim or attached
to the outside of the side trim.
decorative panel
assembly
A
B
• Inside side trim piece: Slide front
edge of routed side panel into trim
piece. Nail rear edge of panel to
support board.
NOTE: KitchenAid is not responsible
for the removal or addition of
molding or decorative panels that
would prevent the refrigerator from
being serviced.
19.
remove protective film from door
frame. Recheck water connections at
bottom of refrigerator for leaks.
cabinet
Install shelves and bins in refrigerator
side trim
and freezer compartments.
20.
package taped to front of refrigerator.
Remove grille and skirt and 2 screws
louver
from package.
assembly
floor
21.
measure the distance from the bottom
of refrigerator cabinet to the floor.
Top view
rear wall
support board
A
side panel
B
side trim
door
Panel Wraparound
models (shown) metal
door models
24" 23"
(61 cm) (58.4 cm)
24-5/8" 23-3/8"
(62.5 cm max.) (59.4 cm)
Open refrigerator doors and
Remove the grille and skirt
refrigerator cabinet
bottom
measure this
distance
Open refrigerator door and
measured distance
(from step 21)
grille and skirt assembly
score "V" groove
22.
Measure this same distance
from the top of the bottom grille to
the closest "V" groove on the grille
skirt.
Use a knife to score down the "V"
groove and break skirt at the score
line.
screws
skirt assembly
23.
Attach the bottom grille and
skirt assembly to the cabinet with the
2 screws.
24.
Set refrigerator and freezer
compartment controls to the midpoint
between "COLD" and "COLDEST."
Check that the compressor is operating
properly and that all five lights are
working.
To get the most efficient use
from your new built-in
refrigerator, read your
KitchenAid Use and Care Guide.
Keep Installation Instructions
and Guide close to built-in
refrigerator for easy reference.
Note: If construction will continue after
refrigerator is installed, rotate control in
freezer compartment counterclockwise
to the "OFF" position.
grille and
Page 11