Installing The Interface Card - Epson ES-1200C Pro PC Getting Started Manual

Installing the Interface Card

Use this procedure to install a SCSI interface card. For more
detailed installation instructions, see the manual that came
with your card.
1. Turn off the computer and any peripheral devices.
2. Disconnect the computer's power cable from the electrical
outlet and from the back panel. Also, disconnect any cables
that are connected to the computer, including the keyboard
cable.
3. Remove the cover from your computer. If you need detailed
instructions, see your computer manual.
4. Before you touch any of the computer's internal
components, touch an unpainted metal surface inside the
computer's case to discharge any built-up static electricity.
5. Choose an option slot for the interface card. You can install
the card in any available slot.
6. Remove any retaining screws from the option slot cover
and remove the slot cover. Keep the screw or screws to
secure the option card to the computer. Store the slot cover
in a safe place in case you later remove the interface card.
7. Unpack the interface card. When handling the card, be
careful not to touch any of the components on the circuit
board or the gold-edged connector.
8. Insert the card into the slot, guiding it straight down. Push
the card down firmly (but carefully) to insert it fully. You
should feel the card fit into place.
9. Secure the end of the card to the back of the computer with
the retaining screw or screws.