Sharp FO-A660 Operation Manual page 77

Note: For all units installed in New Zealand, the direct use of the displayed
number for call back does not operate properly and must not be used. It is
necessary to manually enter the verified correct number for the party called.
This will often require the addition or deletion of leading digits from the
number shown on the display when dialling manually.
♦
After you have received 30 calls, each new call will delete the oldest call.
♦
All calls will be erased if you unplug the fax or a power failure occurs.
Follow the steps below to view the Caller ID List in the display. If desired, you
can immediately dial a number when it appears.
1
Press twice.
2
Press or
3
If you want to dial one of the numbers in the list, scroll through the list
until the number appears in the display.
•
Fax: If you want to send a fax, load the
document and then press
Dialling and transmission begin.
•
Voice call: If you want to make a voice
call, pick up the handset (or press
). Dialling begins automatically. (If
you pressed
when the other party answers.)
4 STOP
Press when you have finished viewing the list.
Caller ID (Requires Subscription to Service)
to scroll through the list.
START/MEMORY
Fax:
, pick up the handset
<REVIEW CALLS>
.
Voice
call:
START/MEMORY
75