Brother MFC-J6910dw Quick Setup Manual page 29

For Wireless Network Users
One-push configuration
20
using WPS (Wi-Fi
Protected Setup) or
AOSS™
a
Confirm your wireless access point/router has
the WPS (Wi-Fi Protected Setup) or AOSS™
symbol as shown below.
b
Place the Brother machine within range of your
WPS or AOSS™ access point/router. The
range may differ depending on your
environment. Refer to the instructions provided
with your access point/router.
c
On your machine, press MENU.
Press Network.
Press WLAN.
Press WPS/AOSS.
When Switch Network interface to
wireless? is displayed, press Yes to accept.
This will start the wireless setup wizard.
To cancel, press No.
Note
If your wireless access point/router supports WPS
(PIN Method) and you want to configure your
machine using the PIN (Personal Identification
Number) Method, see Using the PIN Method of
Wi-Fi Protected Setup in the Network User's
Guide.
d
When the LCD shows Start WPS or AOSS,
press the WPS or AOSS™ button on your
wireless access point/router. See the user's
guide for your wireless access point/router for
instructions.
Then press OK and your machine will now
automatically detect which mode (WPS or
AOSS™) your wireless access point/router
uses and try to connect to your wireless
network.
e
A connection result message appears for
60 seconds on the LCD and a wireless LAN
report will automatically be printed.
If the connection failed, check the error code on
the printed report and refer to Troubleshooting
on page 30.
Wireless setup is now complete. A four
level indicator at the right of your
machine's LCD will show the wireless
signal strength of your access
point/router.
To install MFL-Pro Suite, continue to
step 21.
®
For Windows Users:
Now go to
Page 32
For Macintosh Users:
Now go to
Page 36
29