Basic Connection; Connection Using Aerial Cables And Scart Cables - Sharp DV-HR400F Operation Manual

Basic Connection

Connection Using Aerial Cables and SCART
Cables
The following connection is the basic connection to watch or record TV
programmes.
Important!
• Be sure to turn off and unplug from the AC outlet this Recorder and all
equipment before connecting the cables.
• Read through the operation manual for the equipment to be connected.
NOTE
• To connect using S-video or
component cables, see "Using Other
Types of Video Output" on page 24.
To ANTENNA
IN jack
To ANTENNA
OUT jack
To LINE 1(TV)
SCART
2
Coaxial cable SCART cable
(supplied) (commercially
available)
To SCART
input
To antenna
input jack
TV
Infrared Transmitter
Fix the Infrared Transmitter in
front of the infrared receptor.
Important!
When connecting to your TV using SCART cable:
• When playing back HDD/DVD, the recorder side input is selected
automatically. When the channel is changed at the TV side under this
setting, the selection is normally changed to the reception channel, but it
may not be changed for certain TV models. If this happens, press the TV/
DVD button on the remote control.
• Progressive output works only when the Recorder is connected with TV by
Component video cable.
Aerial cable
1
(commercially available)
The Recorder
6
To LINE 2
SCART
3
4
SCART cable G-LINK
(commercially cable
available) (supplied)
To SCART
output
The external receiver
(satellite system,
cable TV set-top box
or DVB-T(Digital
Video Broadcasting
Terrestrial))
1
2
3
When connecting with your
external receiver
4
6
5
5
NOTE
• Even when you use an external
receiver, you must connect the
Recorder to Aerial via ANTENNA IN
jack.
• According to the input signal from
the external equipment to L2, you
must select the type of video signal
(S-VIDEO or RGB/COMPOSITE) in
"L2" setting. This can be done in
"OTHER SETTINGS" – "ADJUST-
MENT" – "VIDEO/AUDIO SETTING"
– "CONNECTING TERMINAL".
Connect the TV aerial
cable to the ANTENNA IN
jack on the rear of this
Recorder.
Connect the ANTENNA
OUT jack on the rear of
this Recorder to the
antenna input jack on your
TV using the supplied
coaxial cable.
Connect the LINE 1(TV)
jack on the rear of this
Recorder to the SCART
input jack on your TV
using the SCART cable
(commercially available).
Connect the LINE 2(DE-
CODER/EXT) jack on the
rear of this Recorder to the
SCART output jack on your
external receiver using the
SCART cable.
Connect the G-LINK jack
on the rear of this
Recorder with the external
receiver using G-LINK
cable (supplied). Fix the
infrared transmitter of the
G-LINK cable as described
below left. (See page 46)
• If you use DVB-T (Digital Video
Broadcasting Terrestrial),
connect the TV aerial cable to
the DVB-T and the DVB-T to
the ANTENNA IN jack of the
Recorder (see 6 in the chart)
instead of the connection in
the Step 1 above (see 1 in the
chart).
23
GB