Enhancing Your System; Recording To A Cassette Tape - Sharp QT-UH5H Operation Manual

Recording to a cassette tape

QT-UH5H
(continued)
ENGLISH
Recording from CD/USB
1
Set the FUNCTION switch to CD or USB.
2
Load a blank cassette into the cassette compartment with
the side to be recorded on facing up.
3
Press the RECORD
4
When press the STOP/EJECT / button during recording,
display will appear, but CD still spinning.
5
To stop the CD spinning press the
Programmed track recording from CD/USB
1
Select the memories track you want to record.
2
After memories the selected track, press the RECORD
button. The recording for memory track will begin until
end.
3
After recording is completed, disc will stop to rotate, but
tape still rotating.
4
Press the STOP/EJECT / button to stop recording.
Note:
Cassette play and record buttons will automatically release when
the end of tape has been reached.
E-21
button, the recording will begin.
button.

Enhancing your system

Headphone
Before plugging in or unplugging the headphones, make sure the
volume level is reduced.
Be sure your headphones have a 3.5 mm (1/8") diameter plug and
are between 16 ohms and 50 ohms impedance. The recommend-
ed impedance is 32 ohms.
When headphones are connected, the speakers are disconnected
automatically. Adjust the VOLUME control for desired volume.