Audio Dubbing - Sharp Viewcam VL-WD450S Operation Manual

Audio Dubbing

1
Play back the recorded Mini DV cassette
and locate the tape position where you
wish to start audio dubbing.
2
Press y to pause playback.
3
Press the MENU/DISPLAY button until
the menu screen appears.
4
Select V, then press r on the
Operation button. Select "AUDIO DUB"
(1), then press r (2).
• The audio dubbing screen appears.
PL AY BACK SE T
AUD I O
AUD I O
P I C. E F F EC T
PB E F F EC T
MULTI F RAME
AUD I O
S T ART
S T OP
CANC E L
5
Press e to begin audio dubbing.
Record your narration.
AUD I O
S T ART
S T OP
DUB E X ECU T E
1 2 +
AUDIO
DUB
MENU D I SP L AY
AUDIO1 2 +
DUB
To pause audio dubbing
Press e.
To quit audio dubbing
Press the MENU/DISPLAY button. The audio
dubbing screen disappears.
If you wish to change the dubbed audio
or dub additional scenes
1
Press the MENU/DISPLAY button to
turn off the audio dubbing screen.
2
Repeat steps 1 to 5 above.
Notes:
• Audio dubbing cannot be used with record-
ings made in LP mode.
• It is recommended that you use Audio Dubbing
only with recordings made with this camcorder.
Use of recordings made with other digital video
equipment may result in poor audio quality.
• Audio dubbing will automatically pause if the
original audio changes from 12-bit mode to 16-
bit mode or vice versa. Press e to resume
operation.
• Audio dubbing will automatically stop if a portion
recorded in LP mode or an unrecorded portion
of the tape is encountered.
• You can play back the dubbed audio and the
original audio together or separately (see
"Selecting the Audio Playback Mode" on next
page).
70