Watching Playback On A Tv - Sharp ViewCam VL-NZ100E Operation Manual

Basic Operations
Playback
Watching Playback on a
TV
Available modes:
TAPE-VCR, CARD-VCR
You can connect the camcorder to a TV to
allow a larger audience to enjoy playback.
1
Open the jack cover on the camcorder
(see page 2).
Jack cover
2
Connect the camcorder to your TV (or
VCR) with the supplied audio/video
cable, as shown.
Yellow: To video input jack
White: To audio input (L) jack
Red: To audio input (R) jack
Audio/video cable (supplied)
To AV jack
The arrow shows the signal flow.
:
25
VL-NZ100E-E-019-025
CHANNEL
PAUSE
/STILL
PLAY
EJECT STOP/
POWER
TV/VCR SET UP REC
25
Caution:
• Check that the camcorder, TV, VCR and
other equipment to be used are turned off
before making any connections. Picture
noise or malfunction may occur if any of the
above is left on while making a connection.
3
Turn on the TV and set it to the "AV" or
"VIDEO" channel. (See the operation
manual of your TV.)
• When connecting to a TV via a VCR, turn
on the VCR and set it to the "AV" or
"LINE" input channel. Operate the TV as
you normally do to view the signal from
the VCR. (See the operation manuals of
your TV and VCR.)
4
Set the Power switch on the camcorder
to VCR, and begin playback (see page
23).
Notes:
• If your TV or VCR has only one audio input jack,
use the white plug for the audio connection on
the TV or VCR.
• Close the jack cover after use.
02.3.28, 9:08 AM