Audio Dubbing - Sharp ViewCam VL-NZ100E Operation Manual

Audio Dubbing

1
Play back the recorded Mini DV cassette
and locate the tape position where you
wish to start audio dubbing.
2
Press m to pause playback.
3
Press the MENU button until the menu
screen appears.
4
Press l or m on the operation button
to select V, then press the SET button.
5
Press l or m to select "AUDIO DUB",
then press the SET button.
• The audio dubbing screen appears.
P L A Y B A C K
P I C .
A U D I O DU B
A U D I O
A N L G D G T L
R E T U RN
A UD I O D U B
S T A R T
S T O P
6
Press the SET button to begin audio
dubbing. Record your narration.
VL-NZ100E-E-047-054
To pause audio dubbing
Press the SET button. To resume audio
dubbing, press the SET button again.
To cancel audio dubbing
Press the MENU button. The audio dubbing
screen disappears.
If you wish to change the
dubbed audio or dub additional
scenes
1
2
Notes:
S E T • It is recommended that you use Audio Dubbing
E F F E C T
E X E C U T E
• Audio dubbing will automatically pause if the
• Audio dubbing will automatically stop if a portion
• You can play back the dubbed audio and the
1 + 1 +
A UD I O A UD I O 2 2
54
Press the MENU button to turn off the
audio dubbing screen.
Repeat steps 1 to 6 above.
only with recordings made with this camcorder.
Use of recordings made with other digital video
equipment may result in poor audio quality.
original audio changes from 12-bit mode to 16-
bit mode or vice versa. Press the SET button to
resume operation.
recorded in LP mode or an unrecorded portion
of the tape is encountered.
original audio together or separately (see page
52).
02.3.28, 9:12 AM
54