Quick Return; Edit Search - Sharp ViewCam VL-NZ100E Operation Manual

Quick Return

Available mode:
TAPE-CAMERA
If while playing back your tape you want to
quickly return to the last recorded scene and
start recording again, use the quick return
function.
1
Set the camcorder to TAPE-CAMERA
mode.
2
In Recording Standby mode, press the
MENU button until the menu screen
appears.
3
Press l or m on the operation button
to select T, then press the SET button.
4
Press l or m to select "QK. RETURN",
then press the SET button.
S E T T I NG 1
P I C .
S C E N E ME NU
QK .
GU I D E
R E T U RN
5
Press l or m to select "START", then
press the SET button.
• "SEARCH" flashes, and the tape begins
fast forwarding or rewinding to the end
of the last recorded scene.
• When the tape reaches the end of the
last recorded scene, "FINISHED" is
displayed, and the camcorder enters
Recording Standby mode.
6
Press the MENU button to turn off the
menu screen.
Notes:
• To cancel the quick return function while
"SEARCH" is flashing, press the SET button
twice.
• Quick return will not work if you remove the
cassette and reload it after recording or if
nothing has been recorded since loading.
VL-NZ100E-E-031-037
E F F E C T
R E T U RN S T A R T
S T O P
S E A R C H
32

Edit Search

Available mode:
TAPE-CAMERA
The edit search function lets you search,
without switching from TAPE-CAMERA mode to
TAPE-VCR mode, for the point on the tape
where you wish to start recording next.
Operation button
1
Set the camcorder to TAPE-CAMERA
mode.
2
In Recording Standby
mode, press and hold
down j (reverse edit
search) or k (forward
edit search) on the
Operation button.
3
When you find the point where you want
to begin recording, release the button.
Notes:
• The sound is off during search.
• Forward edit search is performed at the same
speed as normal playback, and reverse edit
search at 6.5 times the normal playback.
• You may experience picture noise during reverse
edit search.
02.3.28, 9:10 AM
32