Table of Contents
Advertisement
Installing the Lithium
Battery
Installing
The supplied lithium battery is used to store the
memory of the date and time settings.
1
Slide the cassette compartment door
release and open the cassette compart-
ment door.
Note:
• The cassette holder will extend and open
when the camcorder is connected to a
power source. Be sure to close the cassette
holder before proceeding to the next step
(see page 12).
2
Pull out the lithium battery holder using
a pointed object such as the tip of a
ballpoint pen.
3
Insert the lithium
battery into the
battery holder with
the H side of the
battery facing the
m side of the
holder.
4
Push the battery holder back into
position. Press the W mark gently,
then close the cassette compartment
door by pressing the centre until it clicks
into place.
VL-NZ100E-E-009-018
Removing
Perform steps 1 and 2 above,
then lift out the battery from
the battery holder.
Notes on the Use of the Lithium battery
CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the
same or equivalent type CR2025 recom-
mended by the equipment manufacturer.
X KEEP THIS BATTERY AWAY
FROM CHILDREN. IF SWALLOWED,
CONSULT A PHYSICIAN IMMEDIATELY FOR
EMERGENCY TREATMENT.
Z BATTERY MAY EXPLODE IF
MIS-USED OR INSTALLED WITH POLARITY
REVERSED. DO NOT RECHARGE, DISAS-
SEMBLE OR DISPOSE OF IN FIRE.
Lithium battery
• Do not short-circuit, recharge, disassemble, or
holder
• Should the lithium battery leak, wipe the battery
• The lithium battery will last about one year under
"m" mark
14
heat the lithium battery.
compartment clean, and then insert a new
battery.
normal usage.
02.3.28, 9:07 AM
14
Advertisement
Table of Contents
