Table of Contents
Advertisement
INSTALLING THE LITHIUM BATTERY
1
Open the lithium battery compartment cover with
a pointed object.
Warning:
Dispose
promptly. Keep
of used battery
l
Do not disassemble and do not dispose of in fire.
The battery used in this device may present a fire or chemical
l
burn hazard if mistreated.
Do
not recharge, disassemble,
heat above 100°C or incinerate. Replace battery with type
CR2025 of SHARP CORPORATION, SONY ENERGYTEC,
FUJI ELECTROCHEMICAL or MATSUSHITA ELECTRIC
only.
Use of another battery may present a risk of fire or
explosion.
SETTING THE DATE/TIME
The auto date/time function features a date and time in the viewfinder which can be recorded as a handy reference.
the instructions below to set the current date and time.
Follow
Example: Setting the date to 25th Oct. 1991 and time to 3:27 PM.
1
Install the date/time lithium battery.
Press the INITIAL button using a dull-pointed
object such as a ball point pen.
The month will flash. Press the SELECT button
to select the month. When the correct month
appears, press the SET button.
The hour will flash. Press the SELECT button to
select the hour (check for AM or PM). When
the correct hour appears, press the SET button.
Insert the battery with the " + " side out. Close the
lithium battery compartment cover.
away from children.
This lithium battery is available at a local electronic appliance
l
shop or audio/video shop.
Disconnect the power source
l
before replacing the battery.
The battery life is approximately one year but it differs de-
l
pending on the ambient temperature and the condition of the
lithium battery.
When the lithium battery runs out, the clock may be ex-
l
tremely inaccurate, or the clock setting mode may be
engaged. When this
as soon as possible.
Reset the date and time after replacing the battery.
Do not short-circuit the battery by holding the electrodes with
l
metallic objects such as tweezers, as doing so will deteriorate
the battery quality.
Connect a battery pack or power source. Slide
the OPERATE switch on.
Press the DATE-TIME DISPLAY button (See
page 6 No.33)
The day will flash. Press the SELECT button to
select the day. When the correct d,ay appears,
press the SET button.
SET - SELECT - INmAL
The year will flash. Press the SELECT button to
select the year. When the correct "tens" of the
year appears, press the SET button.
The minutes will flash. Press the SELECT but-
ton to select the minutes. When the correct time
appears, press the SET button.
battery
For
replace-
l
ment, repeat step 2
after removing old
battery.
(AC
adaptor, battery pack, etc.)
occurs, replace the lithium battery
7
Advertisement
Table of Contents
