Radio Operation - Sharp QT-CD131H Operation Manual

<P=002>

Radio operation

Manual tuning
1 2
Set the
FUNCTION
switch to TUNER.
FUNCTION
TAPE TUNER CD
BAND
STAND-BY ON
Preset tuning
You can store up to 30 stations (20 FM stations and 10 AM stations) and recall them at the push of a
button. FM stations can be recalled in either stereo or mono.
1
Perform steps 1 - 3
of the "Manual tun-
ing" section.
4
Within 5 seconds, press the MEMORY button to
store that station in the selected station preset
number memory.
MEMORY
20 FM stations can be preset (preset channels 1 through 20).
10 AM stations can be preset (preset channels 1 through 10).
(There are no presets 11 through 20 for AM stations.)
If the "MEMORY" and preset number indicators go out before the station is memorised, repeat the
operation from step 2.
3
Select the desired fre-
quency band. (FM ST,
FM or AM)
FM STERO
FM
ST
MHz
ST
FM MONO
FM
MHz
AM
KHz
AM
To receive an FM stereo
tra nsmission , pres s th e
BAND button so that the "ST"
indicator on the display lights
j
up.
The " " indicator lights up
when an FM broadcast is in
stereo.
FM
ST
2 3
Press the MEMORY
button.
MEMORY
Th e displa y's "MEM-
ORY", "station number"
and "CH" indicators will
flash.
5
QT-CD131H(SUK) TINSE0007SJZZ
X W
Press the TUNING ( or
ton to tune into the desired sta-
tion.
TUNING
DOWN UP
Holding it down for more than 0.5 sec-
onds will cause the frequency to change
rapidly until the button is released.
If the FM reception is poor, press the
BAND button so that the "ST" indicator
goes out.
Although the reception changes to mon-
aural, the sound becomes clearer.
Please note that when the unit is being
tuned in the FM stereo mode, interim
station noise as well as weak stations
are suppressed. Only in the FM monau-
ral mode, can weak and noisy stations
be received.
X W
Within 5 seconds, press the
PRESET ( or ) button until
the preset number to be pro-
grammed flashes in the display.
PRESET
DOWN UP
5
Repeat steps 1 - 4 to set
other preset stations, or to
change a preset station.
) but-