Radio Operation - Sharp XL-30H Operation Manual

*XL-30H(SUK)P14-P18
Downloaded from: http://www.usersmanualguide.com/

RADIO OPERATION

Tuning
1
3,5,6
2
1
Press the ON/STAND-BY button to turn the
power on.
2
Press the FUNCTION button until "FM" or "AM"
appears in the display.
3
Press the BAND button to select the desired fre-
quency band. (FM ST, FM or AM)
4
Press the TUNING (X or W) button to tune in to
the desired station.
Manual tuning:
Press the TUNING (X or W) button as many times
as required to adjust the frequency shown on the
display to the frequency of the desired station.
Auto tuning:
When the TUNING (X or W) button is pressed for
more than 0.5 seconds, scanning will start auto-
matically and the tuner will stop at the first receiv-
able broadcast station.
Notes:
When radio interference occurs during auto scan
tuning, auto scan tuning may stop automatically
at that point.
If a weak station signal is found during auto scan
tuning, the station will be skipped.
To stop the auto tuning, press the TUNING (X
or W) button again.
5
To receive an FM stereo transmission, press the
BAND button so that the "ST" indicator on the
display lights up.
"j" will appear when an FM broadcast is in
stereo.
6
If the FM reception is weak, press the BAND
button so that the "ST" indicator goes out.
The reception changes to monaural, the sound
becomes clearer.
Note:
The last station tuned in will be recalled, even
after changing the tuning band or the function,
or after switching the unit to the stand-by mode.
Preset tuning
You can store up to 30 stations in memory (30 sta-
tions consisting of any combination of FM and AM
stations you like) and recall them.
4
2,4
To enter stations into memory:
1
Perform steps 1 - 6 in the "Tuning" section.
2
Press the MEMORY/SET button.
"MEMORY" will flash.
3
Within 5 seconds, turn the jog dial to make the
preset channel number flash in the display.
Store the stations in memory, in order, starting
with preset channel 1.
4
Within 5 seconds, press the MEMORY/SET
button to store that station in the selected sta-
tion preset number memory.
If the "MEMORY" and preset number indicators
go out before the station is memorised, repeat
the operation from step 2.
5
Repeat steps 1 - 4 to set other preset stations,
or to change a preset station.
After use:
Press the ON/STAND-BY button to enter the stand-
by mode.
15
15
3
00.2.2, 3:57 PM