Remaining Recording Time Display; Remaining Battery Power Display - Sharp ViewCam VL-E89E Operation Manual

Remaining Recording Time
Remaining Battery Power
Display
Display
When the VIEWCAM is recording in Camera
mode, about 10 minutes before the tape
reaches its end, an on-screen indicator will
begin to show how much time you have left.
You might want to get a new tape ready at this
time.
To turn off the remaining recording time display,
press the MODE DISPLAY button.
1 8 min.-6 min.
1 TAPE0ULlDCl 1
6 min.-4 min.
TAPEDOOOC
4 min.-Z min.
TAPEDl@ilD
2 min.-l min.
TAPEOGOOF
THE TAPE
1
min.-O min.
ENDS SOON.
a
-TAPE END-
0 min.
CHANGE THE
(The tape has
CASSETTE.
reached its end.)
4
TAPE END
Notes:
The time-remaining indicators only show
approximate time left. Also, they vary slightly
depending on the length of tape used. (This
function's design is based on the P5-90 tape
standard.)
If you press the MODE DISPLAY button to turn
off the remaining recording time display, this
display will reappear after a short interval to
indicate the new time remaining.
The time-remaining indicator appears after 5
seconds from the time you press the REC
START/STOP button to start recording.
When you turn on the VIEWCAM, the remaining
battery power display automatically appears on
the monitor. By pressing the MODE DISPLAY
button, you can turn the display on and off.
The remaining power is displayed in three
levels, as shown.
If the battery power is very low, a warning
message will appear. Replace the battery
pack.
mh
(Gree
rc
Free
rc
(Red)
3-level display
Notes:
l
Use the remaining battery power display only as
an indication.
l
Battery consumption may vary depending on the
condition of use.
l
The battery power display may change to either
a higher or lower level if you set the Power
switch to OFF and then back to CAMERA or VCR
again.
26
q