Advertisement
Troubleshooting
If you see a blank screen
If you see a blank screen or the No signal message after turning on
your computer or video source, check the following:
M ake sure the
flashing and the A/V Mute slide (lens cover) is open.
M ake sure the cables are connected correctly. (See the User's Guide
for more information.)
I f you've connected more than one video source, you may need to
press the Source Search button on the projector or the Search
button on the remote control to select the one you want to watch.
(Allow a few seconds for the projector to sync up after pressing it.)
If the picture is taller on one side
T he projector is set at an angle to the screen. Face it squarely toward
the screen.
Epson and Instant Off are registered trademarks and Epson Exceed Your Vision is
a registered logomark of Seiko Epson Corporation. PowerLite and PrivateLine are
registered trademarks of Epson America, Inc.
General Notice: Other product names used herein are for identification purposes only
and may be trademarks of their respective owners. Epson disclaims any and all rights in
those marks.
This information is subject to change without notice.
© 2008 Epson America, Inc. 7/08
Printed in XXXXXX
power light on the projector is green and not
CPD-26345
Advertisement
