Recording To Another Vcr; Edit Control - Sharp VL-C8000X Operation Manual

RECORDING TO ANOTHER VCR

Your SHARP Camcorder can be connected as the playback source deck for dubbing and editing a tape with
another VCR. Unnecessary scenes can be removed, the overall length shortened, scenes moved and rearranged,
and other effects added to make your tapes more effective and enjoyable.
AV OUT terminal
I
Plug the A/V OUTPUT cable into the AV out
terminal on the rear of the Camcorder. Plug the
VIDEO OUT and AUDIO OUT connectors into
the VIDEO IN and AUDIO IN terminals on the
rear of the VCR.
Monitor recording on a IV connected to the
VCR.
Connect a power source to the Camcorder and
the OPERATE switch to ON. Now turn on the
slide
VCR too.
Slide the Camcorder CAMERA RECNCR PLAY
switch to "VCR PLAY" and insert a recorded tape.
Insert a cassette tape with erasure protection
tab intact into the VCR and put it into REC
PAUSE mode.
Locate the scene to be copied from your Cam-
corder and press the PAUSE/STILL button.
Slide the EDIT switch to ON.
Press the PAUSE/STILL button on your Cam-
corder and on the VCR to
dubbing.
Picture
quality inevitably deteriorates with each copy. The
standard tape speed (SP) mode is therefore recommended
on the recording VCR when dubbing a tape.

EDIT CONTROL

Picture quality inevitably deteriorates each time you
dub from the Camcorder to a VCR. Slide the EDIT
switch on to minimize deterioration of picture quality.
Use this while you edit your videos.
28
Recording
RF OUT terminal
To
begin playback and
PAUSE/STILL
button
Normally, the EDIT switch should be off.
l
Monitor
To RF in
(antenna in)