Sharp XL-35W Operation Manual page 10

XL-35W
System connections (continued)
" Setting the AC voltage selector
Check the setting of the AC voltage selector located on the rear
panel before plugging the unit into a wall socket. If necessary, adjust
the selector to correspond to the AC power voltage used in your
area.
Turn the selector with a screwdriver until the appropriate volt-
age number appears in the window (110 V, 127 V, 220 V or 230 V
- 240 V AC).
" Connecting the AC power lead
After checking all the connections have been made correctly,
connect the AC power lead to the AC power input socket, then
into the wall socket.
Notes:
! Unplug the AC power lead from the wall socket if the unit will not
be in use for a prolonged period of time.
! Never use a power lead other than the one supplied. Use of a
power lead other than the one supplied may cause an elec-
tric shock or fire.
9
Wall socket
(230 - 240 V, 50/60 Hz)
" To turn the power on
Press the ON/STAND-BY button to turn the power on.
To set the unit to the stand-by mode:
Press the ON/STAND-BY button again.
02/11/22 XL_35W_SCA_1.fm