Regency Ultimate U38-NG1 Owners & Installation Manual page 13

WARNING!
Do not over tighten the screw.
Recommended to grip the
wrench by the short side.
14) Verify that if the conversion is from
NG to LPG, the screw must be re-
assembled with the red o-ring visible
(Fig. 5).
Red o-ring visible
Fig.5
15) Re-assemble the black protection cap
(Fig. 6).
Fig. 6
WARNING!
Also check that the pilot
and main burner injectors are
appropriate for the gas type.
16) Pull off the pilot cap to expose the pilot
orifi ce.
®
Regency U38-1 ULTIMATE Freestanding Gas Stove
17) Unscrew the pilot orifi ce with the allen
key and replace with the LPG pilot
orifi ce in the kit.
LPG Configuration
18) Remove burner orifi ce with a 1/2"
wrench while using a 9/16" wrench to
hold onto the elbow behind the orifi ce,
then discard the orifi ce.
19) Reinstall new burner orifi ce LPG
stamped #50 and tighten.
20) Reverse steps 3) to 2).
21) Attach the label "This unit has been
converted to LPG" near or on top of the
Serial # decal.
22) Replace yellow "NG" label with red
"LPG" label.
ONLY REQUIRED FOR THE U38
Installation of the DC Sparker:
1) Remove the back pedestal cover by
unscrewing the 4 screws.
Burner Orifi ce
INSTALLATION
2) Remove the front control panel by
unscrewing the 6 screws.
3) Unplug the Piezo Ignitor wire and
remove Piezo Ignitor from the control
panel.
4) Plug up the Piezo Ignitor mounting hole
with the plastic plug.
5) Connect the DC spark generator wires
to the SIT Valve with the screw, which is
provided in the kit.
13