Setting The Id Of The Projector To Be Operated - Epson EMP EMP-1825 User Manual

Specifying the projector(s) that will respond to the remote control when multiple projectors are used
B
Choose the ID you want to set and press the [Enter]
button.
C
Press the [Menu] button to close the configuration
menu.

Setting the ID of the projector to be operated

The ID of the projector to be operated must be set every time the projector
is powered on.
Procedure
Point the remote control at the remote receiver of each of the set
projectors, and then perform the following steps for each.
While holding down the [ID] button, press the number
button corresponding to the ID of the projector to be
operated.
Keep
pressed
Once this setting has been made, only the specified projector(s) can be
operated with the remote control.
You can check which projector(s) can be operated with the
q
remote control as described below.
• Point the remote control at the remote receiver of the
projector you want to check, and then press the [ID]
button. The following is displayed.
When remote control operations are
enabled:
33