Configuring Your Machine When The Ssid Is Not Broadcast - Brother MFC-J4310DW Network User's Manual

Configuring your machine for a wireless network

Configuring your machine when the SSID is not broadcast

(For MFC-J2510/J4510DW/J4710DW)
a
Before configuring your machine we recommend you write down your wireless network settings. You will
need this information before you continue with the configuration.
Check and record the current wireless network settings.
SSID (Network Name):
Communication Mode
Infrastructure
1
TKIP is supported for WPA-PSK only.
For example:
SSID (Network Name):
HELLO
Communication Mode
Infrastructure
NOTE
If your access point/router uses WEP encryption, enter the key used as the first WEP key. Your Brother
machine supports the use of the first WEP key only.
b
Press .
c
Press All Settings.
d
Press Network.
e
Press WLAN.
f
Press Setup Wizard.
g
When Switch Network interface to wireless? is displayed, press Yes to accept.
This will start the wireless setup wizard.
To cancel, press No.
Authentication method
Open system
Shared key
WPA/WPA2-PSK
Authentication method
WPA2-PSK
Encryption mode
WEP
NONE
WEP
AES
1
TKIP
Encryption mode
AES
Network key
—
Network key
12345678
3
3
3
23