Brother MFC-J4310DW Network User's Manual page 31

Configuring your machine for a wireless network
(For DCP-J4110DW, MFC-J2310/J4310DW/J4410DW/J4610DW)
a
Before configuring your machine we recommend you write down your wireless network settings. You will
need this information before you continue with the configuration.
Check and record the current wireless network settings.
SSID (Network Name):
Communication Mode
Infrastructure
1
TKIP is supported for WPA-PSK only.
For example:
SSID (Network Name):
HELLO
Communication Mode
Infrastructure
NOTE
If your access point/router uses WEP encryption, enter the key used as the first WEP key. Your Brother
machine supports the use of the first WEP key only.
b
Press Settings.
c
Press s or t to display Network and then press Network.
d
Press WLAN.
e
Press Setup Wizard.
f
When Network I/F switched to Wireless is displayed, press Yes to accept.
This will start the wireless setup wizard.
To cancel, press No.
g
The machine will search for your network and display a list of available SSIDs. Press s or t to display
<New SSID>, and press <New SSID>.
h
Enter the SSID name. (For information on how to enter text, see the Quick Setup Guide.)
Press OK.
Authentication method
Open system
Shared key
WPA/WPA2-PSK
Authentication method
WPA2-PSK
Encryption mode
WEP
NONE
WEP
AES
1
TKIP
Encryption mode
AES
Network key
—
Network key
12345678
3
3
25