Sleep Mode; Focusing And Positioning The Screen Image - Epson ELP-3500 User Manual

Sleep mode

Focusing and Positioning the Screen Image

22
2 Using the Projector
l
Sleep mode conserves electricity by automatically turning off the lamp
after the projector has not been used for 30 minutes. In sleep mode,
the projector's power indicator is orange and only a minimum amount
of the projector's circuitry remains on. This conserves electricity, cools
the projector, and extends the life of the lamp. When the projector is
in sleep mode, you can press the Power button to start projecting
images, or you can unplug the projector's power cord.
When an image appears on screen, check that it is in focus and
correctly positioned on the screen. To focus the image, rotate the focus
ring, which is the inside ring on the lens. To adjust the size of the
image, rotate the zoom ring, which is the outside ring. Rotate the
zoom ring clockwise to make the screen image larger or
counterclockwise to make it smaller.
If you need to raise or lower the image on the screen, extend or retract
the two feet at the bottom of the projector as follows:
1. Stand behind the projector and support the front of it while you
press the purple release levers located above the feet. This unlocks
the feet so they can move up and down freely. Do not let the
projector drop.
Caution: Do not hold the projector by its lens. This can damage the
lens.