Installation; Positioning; Fitting The Vent Hose - Zanussi TDS 372T Instruction Booklet

Hide thumbs Also See for TDS 372T:
Table of Contents

Advertisement

Positioning

It is recommended that, for your convenience, the
machine is positioned close to your washing
machine.
Whilst drying, the tumble dryer will expel a certain
amount of warm, very moist air, and this should
be removed from the room as quickly as possible
to prevent condensation. In an extremely well
ventilated room or close to an open window, this
may occur naturally.
However, in general, it is better to carry the
dryer's exhaust outside via a 100 mm diameter
flexible hose (available through your dealer);
ending either temporarily at an open window, or
permanently at a fixed ventilation grille, fitted to
an exterior wall or window.
The tumble dryer must be installed in a clean
place, where dirt does not build up.
Make sure there are no obstructing items or
material near the air-intake louvres provided at
the back (e.g. paper, rags etc.).
To keep vibration and noise to a minimum when
the dryer is in use, it should be placed on a firm,
level surface.
Once in its permanent operating position, check
that the dryer is absolutely level with the aid of a
spirit level. If it is not, raise or lower the two
adjustable feet at the front of the machine until it
is.
The feet must never be removed.
Do not restrict the floor clearance through
deep-pile carpets, strips of wood or similar.
This might cause heat build-up which would
interfere with the operation of the appliance.
Important
When operating the tumble dryer, the room
temperature must not exceed 35°C, as it may
affect the performance of the appliance.

Fitting the vent hose

To simplify the installation, there is a choice of
vent outlets: one at the back, the others in the left
and right-hand side.
Connect the hose to whichever is the more
convenient by pulling the ring nut (A) from the
vent outlet at the back, screwing it on to the hose
and pushing it firmly back into place.
The unused vents should now be sealed with the
special snap covers provided.

INSTALLATION

P0046
P1028
A
P1027
A
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tds 302t

Table of Contents