Advertisement
CURRENT
READING
HOLD
BUTTON
AND MEMORY
RECALL
To hold the information
of the current
reading,
press the Hold button° The level can
hold nine different
readings
in its memory.
To read out the measurements,
press the
Memory
Recall button,
The last nine measurements
can be read out, beginning
with
the most recently
saved.
To make a new measurement,
press the hold button
to
return to measuring
mode.
USmNG CONVERSION
BUTTON
TO CHANGE
DISPLAY
UNITS
The conversion
button changes
the measurement
units from degrees
(o) to pitch
(in/ft) to slope percent
(%)° Pitch readings
are in 1/8-ino per foot increments_ Plus
and minus signs indicate
when the pitch is slightly
more (+) or less (-) than true
level shown on the display_ The conversion
button can be used even when the
display
is in the HOLD mode_ This feature
is a convenient
way to convert
angles
from one unit to another,
For example,
a 5-in/ft.
roof pitch measurement
can
be converted
to 22.6 ° for setting
up cuts on a chop saw_
ABSOLUTE
ANGLE
AND RELATIVE
ANGLE
MEASUREMENTS
ABSOLUTE ANGLE MEASUREiVIENT
1. Lay the digital laser level on a working surface with the base flat against the surfacer
2o When level power is turned on, the display indicates the absolute
angle between
"level" and working surface.
The zero line indicates
the level position,
and the arrow
indicates
the direction
of the working surface
either above or below level_
3o To activate the beeper, push the beeper
button_ The beeper will sound when the
level is at 0° (level), 45 °, and 90 ° (plumb)° To deactivate
beeper, push button
a second time.
4o To save the measured
angle in memory,
press the hold button° This level can
remember
the last nine measurements.
To display the data in memory, press the
memory
recall button to recall recorded
angles. The level will read out the data
starting
with the most recent measurements
and going backwards
to the earliest
in its memory.
5. To take a new measurement,
press the hold button to return to measurement
mode.
RELATIVE ANGLE MEASUREMENT
1_ Lay the digital laser level on the First working
surface,
2. Turn on the level. The LCD screen
indicates
the absolute
angle between
true level
and the working surface.
3. Press the ZERO button to enter relative angle measurement
mode_ The current
angle will be considered
to be 0.0 ° and the display will read 040°,
4o Place the digital level on the Second
working
surface and the relative angle between
the First working surface
and the Second
working
surface
will be displayed_ The
zero line indicates
the First working
surface
position,
and the arrow indicates
the direction
of the Second working
surface
either above or below the First
working
surface
level
5o At this point you can change the display units for the measured
angle from degrees
(o) to pitch (inch/foot)
or slope (%) by pressing
the conversion
button_
15
Advertisement
