Upper Handle And Crank Assembly - Sears Craftsman C950-52009-0 Owner's Manual

ASSEMBLY
UPPER HANDLE AND CRANK ASSEMBLY 5.
1. Loosen, but do not remove the screws, flatwashers, lock-
washers and hex nuts in the upper holes of the lower han-
dle.
2. Raise upper handle into operating position. Upper han-
dle should be to the outside of the lower handle.
NOTE: Make sure the cables are not caught between
the upper and lower handle.
3. Install hardware supplied in the parts bag (bolt, flatwash-
er, Iockwasher, and hex nut) into right lower hole of upper
handle (See Figure 6). Do not tighten until all bolts are in
place.
4. Install hardware supplied in the parts bag (bolt, flatwash-
er, lockwasher and hex nut) into right lower hole of upper
handle (See Figure 5). Do not tighten until all bolts are in
place.
Locate crank assembly removed from carton earlier and
remove the 3/8" nylon Iocknut and flatwasher from the
eye bolt assembly.
6. Install the eye bolt through the lower hole on the left hand
side of the handle. (See Figure 5).
7. Install the eye bolt through the lower hole on the left hand
side of the handle. (See Figure 6).
8. Install the 3/8" flatwasher and the 3/8" nylon locknut.
9. Carefully remove cotter pin, clevis pin, and universal joint
pin from yoke end of crank rod assembly. (Figure 7)
10. Place universal joint into end of worm gear lining up large
holes. Insert the universal joint pin. Make sure the open-
ing in pin is in line with small openings in universal joint.
Eye Bolt
_- 5/16-18x2"
318" Nylon 5/16-18'
P__ Jkocknut Nut _ '\
11/32 "Flatwashe_
Flatwasher
Figure 5
11. Place yoke end of crank rod around universal joint lining
up openings. Insert clevis pin through assembly and se-
cure with cotter pin. Spread ends of cotter pin to lock in
place.
12. Tighten nut on eye bolt, keeping eye in line with the rod
while tightening the inside securely.
13. Tighten all handle bolts.
NOTE: Make sure crank does not touch carburetor
cover.
Crank
Eye Bolt
3/8" Nylon
"_"'-,, 5/16-18x2"
Bolt
5/16-18" } It
Lockwasher _I _
11/32 "Flatwashe_
Flatwasher Figure 6
Crank Rod
Assembly
Drilled Pin
Figure 7
F_01136J 9