OPERATION
Get to know your snow blower and its controls. Be sure you (or any other operator) have read and understood the Operation
Precautions listed on page 2 of this manual.
Electric Start Button
Oil Fill Cap/Dipstick
Primer Button
Carburetor
Cover
Traction Drive
Auger Drive
Clutch Lever
Clutch Lever _
Tracti°a_lDrive
Auger
C
11
Crank
It
Assembly
Speed
Lever
Starter Handle
Choke
\
Ignition Key
Throttle Control
Lever
Toolbox
Snow Chum
Deflec_r
Auger Housing
Height
Adjust Skid
Figure 10
ENGINE
AND SNOW BLOWER
OPERATING
CONTROLS
The engine operating controls and their functions
are as
follows:
Throttle Control Lever - This snow blower is equipped with
an engine mounted throttle control lever used to start a cold
engine.
Choke Lever-
Set choke lever to ON CHOKE position to
start a cold engine.
Electric Start Button- Used to start the engine using the
120 volt electric starter.
Prime Button- Used to inject fuel directly into carburetor
manifold to insure fast starts in cool weather.
NOTE: Do not move speed select lever while Traction
Drive Clutch is engaged.
This may result in severe
damage to drive system.
Auger Drive Clutch Lever- Used to engage and disengage
the auger and impeller. To engage push down, to disengage
release.
Traction
Drive Clutch Lever-
Used to propel snow blower
forward or reverse.
Push down to engage,
release
to
disengage.
Snow Chute Deflector- Changes the direction the snow is
blown.
Ignition Key- Must be inserted into ignition key slot to start
engine. Pull out to stop. Do not turn ignition key.
Starter Handle-
Starts the engine manually.
The snow blower operating
controls and their functions
are as follows:
Speed Select Lever- Allows the operator to use one of six
(6) forward and two (2) reverse speeds. To shift, move speed
select lever to desired position.
Fq)01136J
11
Crank-
Used to change direction of the snow discharge.
Turn handle clockwise to turn chute to right. Turn handle
counter clockwise to turn chute to left.
Height Adjust Skid- Used to adjust ground clearance of
auger
housing
(see
To
Adjust
Skid
Height
in
the
Adjustment/Repair
section of this manual).
Toolbox
- Spare shear pins and spacers are located in
toolbox.