Craftsman 351.229000 Instruction Manual page 15

Figure 5-3 Figure 5-5
G F
H
N
M
NOTE: Make certain that the chuck arbor (F) and the
tapered hole in the chuck (G) are clean and free of
grease, lacquer, or rust preventive coatings. See
Figure 5-3.
.
Open the chuck jaws completely, hold the top collar
(H) and turn the chuck barrel (I) counter-clockwise.
Make sure the jaws are completely recessed inside
the chuck. See figure 5-3.
7. Place cord sleeve (M) onto light cord (N). See
Figure 5-5.
Figure 5-6
©
Figure 5-4
P
L
0
5. Seat the chuck onto the chuck arbor as far as it will
go.
.
Carefully drive the chuck and chuck arbor into the
drill press spindle (J). Place a wooden block (K)
under the chuck and tap the block up with a
hammer (L). See Figure 5-4.
CAUTION: DO NOT tap directly on the chuck with a
metal hammer.
.
Place cord clamp (0) over cord sleeve and attach
the light assembly to the drill press with two M6 x
16mm hex socket head screws and lock washers
(P). See Figure 5-6.
NOTE: The light assembly can be mounted on either
side of the drill press.
15