Craftsman 351.229000 Instruction Manual page 14

Figure 4-4
DRILL PRESS HEAD AND
MOTOR ASSEMBLY
O
K
The drill press is a heavy machine; two people may
be required for certain assembly operations.
MAKE CERTAIN the drill press is disconnected from
the power source.
Figure 5-1
A
,
Assemble the threaded end of the table rotation
lock handle (L) into hole (M) in the front, right side
of the table support. Do not completely tight handle
at this time. Note: The table rotation lock handle
is the smaller of the two lock handles.
See Figure 4-4.
Figure 4-5
N
K
B
1. Seat the drill press head (A) on the column (B).
See Figure 5-1
Figure 5-2
D
,
Insert the table (N) into the mounting hole (O) table
support (K). Rotate the table to desired position
and tighten table rotation locking handle. See
Figure 4-4 and 4-5.
,
,
D
Align the drill press head with the table and base.
Tighten the two head locking screws (C). See
Figure 5-2
Thread the three pinion shaft handles (D) in the
three tapped holes located in the pinion shaft (E).
14