Table of Contents
Advertisement
Available languages
Available languages
UNPACKING
AND CHECKING
CONTENTS
This drill press will require some amount of assembly.
Remove all of the parts from the shipping box and lay
them on a clean work surface.
Remove any protective materials and coatings from all
of the parts and the drill press. The protective coatings
can be removed by spraying WD-40 on them and
wiping it off with a soft cloth. This may need redone
several times before all of the protective coatings are
removed completely. CAUTION: DO NOT use acetone,
gasoline or lacquer thinner to remove any protective
coatings on your drill press.
After cleaning, apply a good quality automotive wax to
any unpainted surfaces. Make sure to buff out the wax
before assembly.
Compare the items to figures below; verify that all items
are accounted for before discarding the shipping box.
If there are any missing parts, call Customer Helpline
1-800-897-7709.
• The drill press is a heavy machine, two people may
be required to unpack and lift machine,
If any parts are missing, do not attempt to plug in the
power cord and turn ON the drill press, The drill press
can only be turned ON after all the parts have been
obtained and installed correctly,
Figure 3-1
A
E
C
)
B
A.
Column, table support, rack and ring
B.
Drill press head and motor assembly
C. Table
D. Work light
E. Base
11
Advertisement
Table of Contents
