Jenn-Air JGW8130DDB Installation Manual page 8

ORIFICE CONVERSION
1. FROM NATURAL GAS TO LP/PROPANE GAS:
a. Change the appliance pressure regulator from
natural to LP setting. (See figure 3).
b. Screw the burner orifice hoods down tight against
the pins. (See figure 4B). Use care to not over
tighten. Over tightening can damage the coaxial
pin inside the orifice hood.
c. Adjust burner air shutter to the widest opening
that will not cause the flame to lift or blow off the
burner when cold.
NOTE: Correctly adjusted sealed burners, can
have flames that will lift or blow without a pot over
the burner. These should be adjusted with a pot in
place.
FIGURE 4A
NATURAL GAS
SETTING
FIGURE 4B
LP GAS
SETTING
-8-
2. FROM LP/PROPANE GAS TO NATURAL GAS:
a. Change the appliance pressure regulator from LP
to natural setting. (See figure 3).
b. Screw the burner orifice hoods away from the
pins. (See figure 4A). Approximately 1 1/2 to 2
turns.
c. Adjust burner air shutter to the widest opening
that will not cause the flame to lift or blow off the
burner when cold.
NOTE: Correctly adjusted sealed burners, the
flame will lift or blow without a pot over the burner.
These should be adjusted with a pot in place.
SERVICE - PARTS INFORMATION
WHEN YOUR RANGE REQUIRES SERVICE OR
REPLACEMENT PARTS, CONTACT YOUR DEALER OR
AUTHORIZED SERVICE AGENCY. PLEASE GIVE THE
COMPLETE MODEL AND SERIAL NUMBERS OF THE
RANGE WHICH IS LOCATED ON THE RANGE MODEL
NUMBER PLATE.