Accessories; Maintenance - Craftsman 315.175010 Owner's Manual

MAINTENANCE
HOW TO REPLACE THE BLADE (Continued)
NOTE: Bade teeth point toward the dght of the plate
joiner when hem in normal operating position, The direc-
tion of €of•don is marked on the blade, An arrow on the
bottom of the front base assembly also indicates direc-
tion of rotation, See Figure 2Z
16, Tighten blade screw securely. NOTE: "rum blade
screw clockwise to tighten,
17, Replace rear base assembly, Positionadjustment rod in
its proper place _zsshown in figure 28,
18. Secure rear hese assembly in place with the two spdngs.
Hook one end of each spring in notch on each side of
base assembly, Using needle nose pliers, stretch each
spring and hook it over tabs on bearing plate,
19. Reassemble front base assembly.
20. Replace screws andtighten securely with a screwdriver.
21. Remove screwdriver.
RIt;OvE T,&O.
ooTEo
_BLADE
Fig. 30
GENERAL
Only the parts shown on pads list, page twenty three, ere
intended to be repaired or replaced by the customer. All
other parts represent an important part of the double insuia-
tion system and should be serviced only by a qualified
Sears service technician at an authorized service facility,
Avoid using solvents when cleaning plastic parts. Most
plastic_= are susceptible to vadous types of commercial sot-
vents and may be damaged by their use. Use clean cloths
to remove dirt, dust, oil, grease, etc.
When electric tools are used on fiberglass it has been found
that they are subject to accelerated wear and possible
premature failure, as the fiberglass chips and gtindingsare
highly abrasive to hearings, brushes, commutator, etc,
Consequently it is not recommended that this tool be used
for extended work on any fiberglass material, During any
use on fiberglass it is extremely important that the tool is
cleaned frequently by blowing with an air jet.
ACCESSORIES
THE FOLLOWING RECOMMENDED ACCESSORIES ARE CURRENT AND
WERE AVAILABLE AT THE TIME THIS MANUAL WAS PRINTED.
Item No, 9-25424 #O Blscults (5/8 in. • 1-13/16 in.) ................................................. Package of 50
Item NO. 9-25425 #10 Biscuits (13/16 In, x 2-1116 in.) ............................................... Package of 50
Item No. 9.25426 #20 Bllcuite (15/16 in. • 2-5/16 in,) ......;_ ...................................... Package of 50
_The use of attachments or accessories not listed above might be hazarrtous.
Page 19