Craftsman 315.175010 Owner's Manual page 15

OPERATION
AUXILIARY FENCE
Sse Figures 20.21.
When cutting biscuit slots in workptaces lass than 1-1/2 in.
wide. it is necessary to make an 8_iliew fenoe end mount it
to the bottom of the adjustable fence. Thb fence will pro-
vide a positive stop for the height setting of these small
workpieces.
HOW TO MAKE AUXlUARY FENCE
1. Unplug your plate Joth_r.
2. Cofathlnpieceofwood3.5/81n.xS-1/4in. NOTE: The
thickness ofthe wood will0ause the scale on the vertical
fence of your p_ate_ *,0 rte Ir_oneof. He_t _-
mant settinge must alk>wforthe thicknessofthe suxlliefy
fence when preparing to oof slots.
3. Cut a notch as shown in figure 20 for "Alwing indk'.ator
mark and canted(he markings on boards,
4. Place euxllleP/1ante against boEom ofadJustat_efence.
SGe Figure 21.
5. Ustng screw holes In adjustable fence for a ptatem, math
screw boie Iocatlor,s on auxilier/fence, NOTE: See
figure 20 for screw hole lOCationsand dimensions.
6. Drill 3/16 In. screw hotas in eux_lta_y ter_e. Screw holes
must be countersunk on the bottom so that sorewheeds
will he flush with or below the surface of the auxiliary
fence.
7. Secure auxilierj fence ta adjuetabie tanoe with3/16 In. x
3/4 in. fiat heart machine _Tews. washen_, and hex nuts
as shown In figure 21.
8. Tighten screws securely, making sure screw heads are
flush or subfiush with bottom surface of auxiliary fence.
DUSTLESS FEATURE
see Figures 22.23.
The dust box Io_tad ¢n the rstu of your pinta Joinerprovides
s duet ¢olieoflon system. Wood particiel are drawn up
throughs tunne_ in the base and collectIn the rtustbox dudng
cuttingoheratione. For more efficient operation, empty dust
box when half full,
TO REMOVE DUST BOX FOR EMPTYING
see Figure 22.
1. Unplug your plate joiner.
2. TO reiease rtust box. depress tshe _ocatod on each side
of dust box as shown by the CHOWS in figure 22.
3. Slide dust box to the rear of plate joiner is shown by the
arrow in figure 22. and remove.
4. DO NOT press on the screen matadel withyour hand or
fingers. Screen rnatadel can be damaged. NOTE:
Screen matedal is located on the sides end reel of dust
box.
5. DO NOT break tabs that secure dust box to plate joiner.
6. Empty dust box.
.
1
HEX NUT(E)
WASHER(E)
SCREW(S)
AUXlUARY
FENCE Fig. 21
DUST
BOX
SCREEN
TO
_.REMOVE
DUST BOX