Adjustments - Craftsman 315.175010 Owner's Manual

ADJUSTMENTS
FENCE HEIGHT ADJUSTMENT
S_e Figure
The adjustable fence on your plate joiner can be moved up
and down to adjust the position of the blade in relation to the
top of the workpiece. A scale on both sides of the fence
indicatesthe height of the fence from the center of the blade.
The fence can be positioned up totwo inches from the center
of the blade. However. the scale and indicator pointcan only
be setup to 1-1/2 in.from the center of the blade. Scale marks
are in iilcrements of 1/16 in.
TO ADJUST HEIGHT SETTING
See Figure 5.
1. Unplug your plate joiner.
2. LooSenthetwoheightedjustmentknohe. NOTE: Loosen
each height adjustment knob approximately one turn.
3. Slide the fence up or down until the indicator point is
aligned with the desired dimension on the scale.
4. Tighten height adjustment knobs securely.
FENCE ANGLE ADJUSTMENT
See Figure
The adjustable fence on your plate joiner can be set at angles
ranging from 60 ° above 90 ° to 45° below 90o, with quick,
accurate positive stops set in 15° increments. A scale is
located on both sides ofthe front handle for identifyingthese
positive stop angles. Each click you hear when rotating the
adjustable fence from one angle setting to another equals a
15° positive stop angle change.
TO ADJUST ANGLE SETTING
See Figure 6.
1. Unplug your plete Joiner.
2. Loosenthetwoheightadjustment knops. NO'RE: Loosen
each height adjustment knob approximately one turn,
3. Rotste edjustable fence up or down to the desired angle.
4. Tighten height adjustment knobs securely.
FRONT HANDLE I
_DJUSTABLE FENCE
TO LOWER SE'i-rlNG ,
ADJUSTABLE SCALE
FENCE
ADJUSTMENT
KNOB(S)
TO RAISE
ADJUSTABLE
FENCE
TO LOOSEN
TO _GHTEN
ROTATEADJMSTABLEFENCE
TO DESIRED ANGLE SETTING
INDICATOR
POINT
Fig. 5
Fig. 6
Page 9