Plugging In And Turning On The Tv - Epson LivingStation LS47P2 User Manual

Plugging In and Turning On the TV

After your video and audio equipment are connected and the remote control is ready, you can
plug in and turn on the TV. You may want to turn on your connected equipment and insert a
tape or disc, if necessary, to test the TV with all of its video and audio sources.
1 Plug the power cord into a wall outlet or power strip.
The Power light comes on orange.
2 If you're using the remote control, make sure the equipment switch at the top is in
the TV position.
3 Press the Power button on the TV panel or the remote control.
TV panel
The Power light flashes green while the TV warms up.
After a few moments, the Power light stops flashing and shines green.
4 Press the TV/Video button on the remote control or the TV panel to select the source
you want to look at (TV, DVD, etc.).
Power
Power light
button
Power
TV STB1 STB2 VCR DVD
REC PAUSE SKIP
STOP REW PLAY FF
Photo View Freeze Print
Menu Exit
Select
Photo
Zoom
Prev. Next Rotate
Enter
Select
1 2 3
4 5 6
7 8 9
Ch
0
Enter
TV/Video Mute Favorite
Vol. Ch
Aspect POP Swap Sleep
MTS Guide Ch Prev. Ch Display
Info
Remote control
Note
You can press the
TV/Video button
10 seconds after pressing
the Power button. You
don't have to wait for the
Power light to stop flashing
first.
To turn off the DVI and PC
ports when you're not using
them (so you don't have to
cycle through them with
the TV/Video button), see
the instructions on page 43.
41
Setting Up the TV