Using Your Unit As A Brushcutter - Craftsman 358.798270-32ce Important Manual

32 cc 2-cycle engine 18" semi-automatic head straight shaft brushwacker
Table of Contents

Advertisement

USING
YOUR UNIT AS A BRUSHCUTTER
The 8 inch Brush
Blade is designed
to cut grass, weeds,
and woody brush and small trees up to 2 inches
in diameter.
_k DANGER
- THIS POWER
TOOL CANBE
DyLNGEROUS!
Donotat_ach_blade
to this unit without
the proper
installation
of the Brush
Blade
Adaptor
Kit #952-701616.
Blade usage
requires
the proper
installation
of all parts contained
in the Kit. The Handlebar
in the kit must
be used
as abarrier
between
the operator
and the blade.
Failure
to use the handlebar
can result in serious
injury
to the operator.
This unit can cause serious injury including
amputation or blindness
to the operator and others.
The warnings
and safety instructions
in this manual must be followed to provide reasonable safety and efficiency in
uslng this unit. The operator is respons_le
for fonowing the warnings
and instructions
in this manual and on the unit.
Read the entire
Operator's
Manual before
using this unit!
Restrict
the use of this power tool to persons
who read,
understand,
and follow
the warnings
and instructions
in this manual
and on the unit.
,4.
I
BLADE THRUST
.787" (20ram)
>
8" Brush
Blade
....
(seeAccessoryList for partnumber)
Boots Leg Ouards l' T own
..
[ II !1
Eye Protection
/_ X
\_
(20 meter)
!
_ntact with Cut material.
{
_k DANGER
- BLADE
THRUST
When the spin-
ning
blade contacts anything it does not cut, a dan-
gerous reaction can occur causing the entire unit and
operator to be thrust violently in any direction.
This
reaction is called Blade Thrust. As a result, the op.
erator can lose control of the unit. Use handlebar,
shoulder
strap,
and
keep
shield
in place.
Make
sure others
are at least
30 feet (10 me-
ters)
away.
Keep
blade
sharp.
Cut at full
throttle
and
from
your
right
to left.
Keep
hands,
feet and unit in proper
position;
refer
to "Guard
Against
Blade
Thrust."
DANGER
- PROPER
BLADE
Use only
the 8 inch Brush
Blade
and proper
hardware
as shown.
The use of any other parts
can result in serious injury. Do not use any acces-
sory
or attachment
other
than
those
recom.
mended
by the manufacturer
for use with this
unit.
Blades that are bent, warped, cracked, broken,
or damaged
can fly apart and cause serious injury.
Do not use; Throw
away.
WAF_NING
- THROWS
OBJECTS
The
rapidly moving
blade
causes
objects
to be
thrown
violently.
The shield will not provide com-
plete protection
to the operator
or others.
The op-
erator must wear a safety face shield or goggles. Al-
ways wear safety leg guards and boots. Keep others
at least 30 feet (10 meters) away.
^WARNING
- HAZARD ZONE
&L
This unit will throw objects and cut. Keep others
including
children,
animals,
bystanders,
and
helpers
at least 30 feet (10 meters)
away from
the operator
and unit.
Stop the eng_me and
blade immediately
if you are approached.
In areas where other people and animals
are present, such as near sidewalks, streets, houses,
etc., it is strongly
recommended
that the operator
use the buddy system; that is, have another
person
.serve as a "look out,?' keeping himself and others at
least 30 feet (10 meters) away from the operator.
WAP_TING
- COASTING
BLADE
The blade
continues
to spin after the engine
is
stopped or the throttle
is released.
The coasting
blade can thrust, throw objects, or seriously cut you
if accidentally
touched.
Stop the blade
by leav-
ing it in contact
with
material
alread_
cut.
Use the "9 o'clock"
pos_hon
as the point
of
contact.
- 15 -

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

358.798270

Table of Contents