Xerox FlowPort Setup Manual page 21

Configuring a Document Centre 220/230/332/340/432/420/425/432/440 with Centreware Internet Services
Testing the FlowPort Template
To check that the Document Centre is ready for FlowPort use, perform the
following test:
At the Document Centre, place a document in the scanner.
1
2 Select the FlowPort template and select Scan.
Note: If the Document Centre is properly configured, a DC confirmation
sheet will be printed confirming that the scan to FlowPort was
successful, otherwise an error report with some specific failure notice
will be printed. If the scan to FlowPort was successful a FlowPort
confirmation sheet will also print.
Xerox Document Centre Setup Guide for FlowPort 21