Dram Configuration - Gigabyte GA-MA790X-UD4P User Manual

DRAM Configuration

CPU Host Clock Control
x CPU Frequency (MHz)
Set Memory Clock
x Memory Clock
(Note)
DCTs Mode
DDRII Timing Items
x CAS# latency
x RAS to CAS R/W Delay
x Row Precharge Time
x Minimum RAS Active Time
x 1T/2T Command Timing
x TwTr Command Delay
x Trfc0 for DIMM1
x Trfc2 for DIMM2
x Trfc1 for DIMM3
x Trfc3 for DIMM4
x Write Recovery Time
x Precharge Time
x Row Cycle Time
: Move
Enter: Select
F5: Previous Values
x RAS to RAS Delay
: Move
Enter: Select
F5: Previous Values
CPU Host Clock Control, CPU Frequency (MHz), Set Memory Clock, Memory Clock
The settings under the four items above are synchronous to those under the same items in the
MB Intelligent Tweaker(M.I.T.).
DCTs Mode
(Note)
Allows you to set memory control mode.
Ganged
Unganged
DDRII Timing Items
Manual allows all DDRII Timing items below to be configurable.
Options are: Auto (default), Manual.
(Note) This item is present only if you install a CPU that supports this feature.
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
DRAM Configuration
+/-/PU/PD: Value
F6: Fail-Safe Defaults
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
DRAM Configuration
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Sets memory control mode to single dual-channel.
Sets memory control mode to two single-channel.(default)
[Auto]
200
[Auto]
x2.66 533Mhz
[Unganged]
[Auto] SPD Auto
Auto 5T 5T
Auto 4T 4T
Auto 4T 4T
Auto 12T 12T
Auto - - - -
Auto 2T 2T
Auto 105ns 105ns
Auto - - - -
Auto - - - -
Auto - - - -
Auto 4T 4T
Auto 2T 2T
Auto 17T 17T
F10: Save
Auto 2T 2T
F10: Save
- 4 1 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults
BIOS Setup