Download Print this page

Craftsman 973.112930 Operator's Manual page 8

5-1/2 in. 19.2 volt cordless trim saw

Advertisement

TRIM SAW
973.112930
Blade Diameter
5-1/2 in.
Blade Arbor
318 in.
Cutting Depth at 90 °
1-9/16 in.
Cutting Depth at 45 °
1-1/8 in.
No load Speed
4,500 RPM
Motor
19.2 Volt DC
CHARGER
Input
Charging Voltage
Charge Rate
BATrERY PACK
ITEM NO. 9 11041
(1425301)
120 v, 60 Hz, AC only
7.2 - 24 Volts
t Hour
ITEM NO. 9_ 11375
(1310715)
Your trim saw has been shipped completely assembled
except for the blade. Inspect it carefully to make sure no
breakage or damage has occurred during shipping. If any
parts are damaged or missing, contact your nearest Sears
Retail Store to obtain replacement parts before attempting
to operate saw. A blade, blade wrench (5 mm hex key), rip
guide (edge guide) and this operator's manual are also
included.
,_
WARNING:
If any parts are missing, do not operate
your saw until the missing parts are replaced. Failure to
do so could result in possible serious personal injury.
The following recommended
accessories are currently available at Sears Retail Stores.
5-1/2 in. Thin Kerf Blade
_lb
WARNING:
The use of attachments or accessories not listed might be hazardous.
KNOW YOUR TRIM SAW
See Figure 1.
Before attempting to use your trim saw, familiarize yourself
with all operating features and safety requirements.
Features include easily operated bevel cut and depth of
cut adjustment mechanisms; positive 0 ° bevel stop;
spindle lock; and blade wrench storage.
,_
WARNING:
Do not allow familiarity with your saw
to make you careless. Remember that a careless
fraction of a second is sufficient to inflict severe
injury.
SWITCH
Your saw is equipped with a lock-off button which reduces
the possibility of accidental starting. The lock-off button is
located on the handle above the switch trigger. You must
depress the lock-off button in order to pull the switch
trigger. The lock resets each time the trigger is released.
Note: You can depress the lock-off button from either the
left or right side.
APPLICATIONS
(Use only for the purposes listed below)
Cutting all types of wood products (lumber, plywood,
paneling).

Advertisement

loading