Advertisement
• Whenmaking a cutusesteady, e venpressure.
Never f orcecuts.
• Donotcutwarped or wetlumber.
• Always holdyoursawfirmlywithbothhands andkeep
yourbodyin a balanced position so asto resistthe
forcesofkickback shoulditoccur.
When using your saw, always stay alert and exercise
control. Do not remove your saw from workpiece
while the blade is moving.
DEPTH
OF CUT ADJUSTMENT
Always keep correct blade depth setting. The correct
blade depth setting for all cuts should not exceed 1/4 inch
below the material to be cut. More blade depth will
increase the chance of kickback and cause the cut to be
rough. One blade tooth below the material to be cut works
best for most efficient cutting action.
TO ADJUST
BLADE
DEPTH
•
Remove battery pack from saw.
WARNING:
Failure to remove battery pack from
saw could result in accidental starting causing
possible serious personal injury.
•
Loosen depth adjustment knob. See Figure 14,
TO RAISE
SAW
TO
LOOSEN
DEPTH
TO
ADJUSTMENT
LOWERSAW
KNOB
,TO
TIGHTEN
BASE
ASSEMBLY
Fig. 14
•
Hold base flat against the workpiece and raise or lower
saw until the required depth is reached.
•
Tighten depth adjustment knob securely.
STARTING
A CUT
Know the right way to use your saw.
See Figure 15.
Never use your saw as shown in figure 16.
Fig, 15
WRONG
Fig. 16
Never place your hand on the workpiece behind your
saw while making a cut.
,_
WARNING:
To make sawing easier and safer,
always maintain proper control of your saw. Loss of
control of your saw could cause an accident resulting
in possible serious injury.
16
Advertisement
