For Interfaces Other Than Serial Interface - Epson TM T70 Technical Reference Manual

For Interfaces Other Than Serial Interface

The following DIP switch functions are for the parallel/USB/LAN/wireless LAN interface.
DIP switch bank 1
SW Function
1-1 Auto line feed
1-2 Receive buffer capacity
1-3 Reserved
1-4 Error signal output
1-5 ∼
Reserved
1-8
DIP switch bank 2
SW Function
2-1 Handshaking (BUSY condition)
Reser ved (Do not change
2-2
settings)
2-3 ∼
S e l e c t s p r i n t d e n s i t y / L ow
power consumption mode
2-4
2-5 Reserved
2-6 ∼
Reser ved (Do not change
settings)
2-7
IF pin 31 reset signal (Do not
2-8
change settings)
• For DIP switch 2-1 (BUSY condition), see also
• Do not change the setting of DIP switches 2-2, 2-6, and 2-7. Otherwise, the printer may
not operate normally.
ON
Always enabled Always disabled
45 bytes
—
7 bits
—
ON
• Offline
Receive buffer full
• Receive buffer full
Fixed to OFF
See "Selecting the Print Density (DIP Switch
2-3/2-4)" on page 36.
—
Fixed to OFF
Fixed to ON
"Selecting the BUSY Status" on page
Chapter 2 Setup
Factory
OFF
setting
OFF
4 KB OFF
— OFF
8 bits OFF
— OFF
Factory
OFF
setting
OFF
OFF
OFF
— OFF
OFF
ON
37.
35
2