Connectors; Offline - Epson TM T70 Technical Reference Manual

• Lights when the end of the roll paper is detected, and when printing has stopped (offline). If
this happens, replace the roll paper.
• Flashes when an error occurs. (For details about the flash codes, see
• Goes out during regular operation (online).
POWER LED (green)
• Lights when the power supply is on.
• Goes out when the power supply is turned off.

Connectors

All cables are connected to the connector panel on the lower rear of the printer.
Drawer kick-out connector
• Drawer kick-out connector:
• Power supply connector:
• Interface connector:
The picture above shows a serial interface model. For details on the various interfaces and
how to connect the power supply connector and cash drawer, see
to the Host Computer" on page 39

Offline

The printer automatically goes offline under the following conditions:
• During power on (including resetting with the interface) until the printer is ready
• During the self-test
• While roll paper is fed using the FEED button.
• When the printer stops printing due to a paper-end (if an empty paper supply is detected by
the roll paper end sensor or if the driver has been set to stop printing when a roll paper near-
end is detected)
• When an error has occurred
DK
24V
FG
Power supply connector
Interface connector
Connects the cash drawer.
Connects the power supply unit
Connects the printer with the host computer interface.
and "Connecting the Cash Drawer" on page
Chapter 1 Product Overview
"Error Status" on page 16.)
FG
"Connecting the Printer
48.
15
1