Advertisement
Available languages
Available languages
Accessories
Required
IMPORTANT: Line pressure or hose
inside diameter should be increased
to compensate for unusually long air
hoses (over 25 feet). Minimum hose
diameter should be 3/8" I.D. and
fittings should have 1/4" NPT thread.
Operation
Before each use:
•
Drain water from air compressor
tank and condensation
from
air lines. See air compressor's
operators manual.
_
isconnect
the ratchet
wrench from the air supply
before lubricating or
changing sockets.
Lubricate tool, see "Maintenance"
section in this manual.
_
Impact
wrench
sockets and accessories
must be used with this tool.
Do not use hand sockets
and accessories.
Select the required impact
socket. This tool has a 3/8"
square drive, use 3/8" deep
sockets. Use 3/8" extensions only
Connect tool to air hose of
recommended
size. NOTE: The
use of a quick connect set makes
connecting easier.
IMPORTANT:
The use of air
filters and air line lubricators
is
recommended.
To use:
•
Turn air"compressor
on and allow
air tank to fill.
•
Set the air compressor's
regulator
to 90 PSI. This tool operates
at a
maximum
90 PSI pressure.
•
Place tool in forward
or reverse
position.
Bu_on
Throttle
Control
Lever
/
F
Air Inlet
•
Depress the throttle control
lever to operate tool. NOTE:
The throttle control lever
provides instant response when
depressed.
•
Release throttle control lever to
stop tool.
•
Always disconnect
air supply
when changing sockets.
•
When job is complete, turn the
air compressor
off and store as
described in the air compressor
operator manual.
Tips
•
Drive the fastener until the ratchet
stalls and then further tighten
by operating the air ratchet in
the same manner as a manually
dperated ratchet.
Advertisement
