Craftsman 113.23800 Owner's Manual page 9

12. Replace the Lathe pulley. Position it so that the end of
the pulley is ftush with the end of the lathe spindle.
t3. Place the motor pulley on the motor shaft so that the
small diameter is approximately t/16" away from motor.
14. NOTE: When installing the pulley on a 5/8" diameter
motor shaft, make sure that the 3/16" square key fur-
nished with your motor is in place. Then tighten the
setscrew with a 5/32" setscrew wrench.
/
/
3/16 x 3/16 KEY
15. When installing the pulley on a 1/2" diameter motor
shaft, make sure that the adapter sleeve and 3/1 6"
square key furnished with your motor are in place. Then
tighten the setscrew with a 5/32" setscrew wrench.
16. Place the belt on the pulleys and push the motor toward
the back until all the slack is removed from the belt.
Tighten only two of the motor mounting bolts using a
7/16" wrench.
ADAPTER SLEEVE
1/2 DtA. MOTOR SHAFT
17. Place a straightedge such as a piece of wood, metal or
framing equare across the pulleys to see if they are both
in line. If they are, tighten the other two motor mounting
bolts. If they are not in fine, loosen the two motor bolts
and move the motor sideways.., tighten the bolts.
18. Find four pan head wood screws 1/2" tong from among
the loose parts.
/
Attach the belt guard plate to the bench with the two
screws. Make sure the plate is PARALLEL to the belt.