Craftsman 113.23800 Owner's Manual page 12

assembly
4. To lock switch in OFF position... HOLD switch IN with
one hand, REMOVE key with other hand.
WARNING: FOR YOUR OWN SAFETY, AL-
WAYS LOCK THE SWITCH "OFF". WHEI_
LATHE IS NOT IN USE . . . REMOVE KEY
AND KEEP IT INASAFE PLACE... ALSO,.,
INTHE EVENT OF A POWER FAILURE (ALL
OF YOUR LIGHTS GO OUT) TURN SWITCH
OFF ... LOCK IT AND REMOVE THE KEY.
THIS WILL PREVENT THE LATHE FROM
STARTING UP AGAIN WHEN THE POWER
COMES BACK ON,
CHECK MOTOR ROTATION
The Lathe must rotate counterc ockw se when viewed from
the spindle end.
NOTE: Make sure the spur center is removed from the
spindle.
1. Plug the Lathe power cord in[o a properly' grounded
outlet (See page 41,
2. Stand clear of the Lathe spindle and turn the switch ON,
Notice the rotation of the spindle, If it is NOT turning
COUNTERCLOCKWISE . . Remove the Lathe power
cord plug from the outlet and change the rotation of
the motor according to the directions furnished with
the motor.
WARNING: FOR YOUR OWN SAFETY, MAKE
SURE PLUG IS NOT CONNECTED TO POWER
SOURCE OUTLET WHEN CHANGING MOTOR
ROTATION.
ROTATION
TERMINAL
COVER
12